MB QUART NA2-400.2

                     CLASSnFull Range Class D

nn

n
• n
  n
  • VARIABLE VOLTAGEn0.2V~9V

  n

  • SIGNAL TO NOISE RATIOn>90dB

  n

  • FREQUENCY RESPONSEn20Hz-20kHz

  n

  • CROSSOVER TYPEnElectronic 12dB Per Octave

  n

  • LOW PASS CROSSOVERnSWITCH LOW PASS 300 HZ

  n

  n

n

n

n
• BASS BOOSTn0-12dB@45Hz

n

• SUBSONIC FILTERn60Hz

n

• POWER @ 2-OHMSn2 x 200W

n

• POWER @ 4-OHMSn2 x 100W

n

• TOTAL CHANNELSn2

n

• AUDIO INPUTSnRCA

n

• POWER TERMINAL 12V/GNDnMolex 10 ga

n

• SPEAKER TERMINAL WIRE GAUGEnMolex Plug Connector

n

• FUSINGn1 x 30 Amps

n

• CERTIFICATIONSnMarine & Powersports

n

• DIMENSIONSn3.70 X 5.51 X 1.77 inn9.4 X 14.0 X 4.5 cm

n

• WEIGHTn2.12 lbs (0.96 kg)

n

n n

n
• MARINE GRADE PROTECTION: YESnAmplifiers are ASTM certified which defines that marine amplifiers must use conformal coated PC boards to resist corrosion from salt spray & moisture.

n

• PRE-AMP CIRCUITRY: Q-Stasis Pre Amplifier StagenThe highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality

n

• INPUTS: 1 Pair, RCA Nickel-PlatednHigh temperature impact resistant with hex screw terminals that allow for secure connections and is erosion resistant

n

• OPERATION MODE: Two channel operationnFlexible installation allows this amplifier to run in two channel or bridged mono mode.

n

• CROSSOVER / SIGNAL SHAPING: Switched FULL / LPF / HPFnComplete control of amplifier signal, essential when using two or more amplifiers

n

• CLASS / TOPOLOGY: Full Range Class DnHighly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.

n

• OUTPUT DEVICES TECHNOLOGY: PWM MOSFET Power SupplynStable power through the PC board with minimal heat generation

n

• HEAT SINK: AluminumnQuickly dissapates heat to allow the amplifer to run lower impedance for longer duration

n

• POWER SUPPLY: Simpatico Coil DesignnThe dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices

n

• OUTPUT CONNECTIONS: Quick Dissconect Wires, RCA ConnectionsnQuickly remove amplifer when you are putting machine up for the winter of as a security precaution

n

• CONNECTIONS TYPE: Nickel-plated connectionsnNickel plated corrosion resistant connections

n

• DIAGNOSTICS: Three-stage protection circuitsnMonitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel

n

• MARINIZED / WATERPROOF: YESnWater resistant for durability in any environment

n

n