MB QUART RIDE COMMAND SPECIFIC AMP NA2-400.2RC (FREE SHIPPING)

$249.99

-

MB QUART RIDE COMMAND SPECIFIC AMP NA2-400.2RC (FREE SHIPPING)

 

Category: Tag:

Description

Two Channel, RIDE COMMAND compatible 400 watt Powersports amplifier with simple installation with quick release connectors.

  • 200 Watts x 2 Channels
  • Ultra Quiet Integration with RIDE COMMAND
  • Adjustable Gain
  • CLASS
    Full Range Class D
  • TOTAL CHANNELS
    2
  • POWER @ 2 OHMS (CH X WATTS)
    2 x 200
  • POWER @ 4 OHMS (CH X WATTS)
    2 x 100
  • VARIABLE VOLTAGE
    0.2V~9V
  • SIGNAL TO NOISE
    >90dB
  • FREQUENCY RESPONSE
    20Hz-20kHz
  • POWER TERMINAL 12V/GND
    Molex 10 ga
  • SPEAKER TERMINAL WIRE GAUGE
    Molex Plug Connector
  • FUSING
    1 x 30 Amps
  • MARINE GRADE PROTECTION/IPX RATING
    Meets or exceeds IPX5 standards.
  • LOW NOISE PREAMPLIFIER CIRCUIT
    The highly engineered Q-Stasis pre-amplifier stage reduces incoming noise from source units dramatically improving sound quality.
  • RCA INPUTS
    1 pair high temperature impact resistant nickel-plated RCA inputs with hex screw terminals that allow for secure connections and is erosion resistant.
  • OPERATION MODE
    Flexible installation allows this amplifier to run in two channel or bridged mono mode.
  • CLASS/TOPOLOGY
    Full Range Class D: Highly efficient circuit topology which helps the amplifer develop a lot of power in a very small heatsink.
  • OUTPUT DEVICE TECHNOLOGY
    PWM MOSFET Power Supply: Stable power through the PC board with minimal heat generation.
  • HEAT SINK
    Aluminum: Quickly dissapates heat to allow the amplifer to run lower impedance for longer duration.
  • POWER SUPPLY
    Simpatico Coil Design: The dual coil Pulse Width Modulated power supply keeps voltage constant through the Ultra-Fi output devices.
  • OUTPUT CONNECTIONS
    Quick Disconnect Wires, RCA Connections: Quickly remove amplifer when you are putting machine up for the winter of as a security precaution.
  • CONNECTION TYPE
    Nickel-plated connections: Nickel plated corrosion resistant connections.
  • LED SYSTEM PROTECTION CIRCUITRY DIAGNOSTICS
    Three-stage protection circuits: Monitor thermal, overload, DC, and speaker short protection with lighted indicators on the amplifier end panel.